Erica Domesek is the founder, creator and author of
P.S.- I made this…, a distinguished DIY design and style blog. She’s based in New York City where she encourages everyone to embrace her creative motto: “I see it. I like it. I make it.”

Everyone needs to tote around a few devices these days, but when it comes to electronics cases, there aren’t too many fashionable and inexpensive options to choose from.

With DIY infused in my DNA, I am programmed to create things that make my life more beautiful and fun. Inspired by all of the bold striped patterns and color blocking styles seen on the runway this season, I thought it fitting to make my own
iPad clutch out of common materials.

Even if you’re “craft-challenged,” I guarantee anyone can create a one-of-a-kind iPad case in about 15 minutes. Here’s how.

HOW TO: Make an iPad Case Using Common Household Materials

Ingredients
- Kitchen drawer liner (available at The Container Store, Bed Bath Beyond, Target – basically any home store)
- A sharp pair of scissors
- Colorful tape. I like duct tape, but gaffer’s tape and even electrical tape will work. You can find what you need at most hardware and art stores.
- Velcro strips – available at most office supply stores, trim shops, and craft stores.

Step 1

Cut the drawer liner to the desired length. Two-thirds will become the pocket and the remaining third will be a flap closure that folds down over the pocket. Once you’ve got it cut to length, fold over one-third to create the pocket.

Step 2

Once you have measured your pocket, use a piece of tape to cover, secure, and wrap around the entire front and back. This will seal the edges.

Step 3

Continue to do so, adding pieces of tape around it until you are satisfied with the design. Make sure you have enough tape to keep your pocket intact without large gaps on the sides.

Step 4

Be sure to smooth the tape flat to make sure there are no air bubbles or bumps.

Step 5

Optionally, tape the other side to prevent fraying.

Step 6

Get creative with your colors and design. Add a monogram or try a bold pattern.

Step 7

Once taped, cut and stick velcro as a closure for the case. One piece should be on the inside flap (bottom), the other on the front flap (top). Be sure to line everything up properly so the case closes well.